Get stuff out of grand actions.

Grand piano fallboardThe cross section in figure A of a grand piano shows how the grand FALLBOARD (the cabinet part that drops down over the keyboard) creates a natural chute into the action for pens, pencils, small toys and anything else that might be setting on the music rack.

Fortunately, retrieval of these objects is fairly easy on most modern grands such as Yamaha, Samick, Kawi, Young Chang, Steinway, Baldwin, etc. On those models, the fallboard may simply lift off. On older grands a few wood screws may need to be removed.

Grand fallboard pinsAs can be seen in these illustrations, the fallboard sets on metal pins inserted into the cabinet on either end of the keyboard. The inset in figure A shows the metal bracket attached to the edge of the fallboard.

The whole fallboard pivots on these pins and brackets, so as to be raised or lowered over the keyboard at your whim. In most cases it should lift easily up and out.

On older models there may be a small set screw that holds the fallboard tight on the pins, as shown in the inset of figure B. If so, you'll need to loosen the set screws with a small screwdriver (don't remove them completely). Then grip the top of the fallboard and lift it off the pins (it may be heavy so be ready to set it down someplace other than your toes).

With the fallboard removed you'll be able to see directly into the action and you may be amazed, delighted or disgusted at what you find has dropped in there, especially if you have small children.

After retrieving the junk, replace the fallboard by aligning the brackets on the pins and setting it back into place. Raise and lower it once or twice just to make sure it's resting on the pins.

Unfortunately, life is not made so easy on some older grands where the fallboard is connected to the endblocks (the blocks of wood at either end of the keyboard) and requires that both the endblocks and the "keyslip" (the thin strip of wood that runs horizontally in front of the keys) be removed.

The screws holding those two cabinet parts are usually underneath the piano, requiring you to lie on the floor and remove all the screws. This may be more effort than the average owner wants to jump into, though it's easy for your piano tuner to retrieve items from the action when tuning the piano.

Return to top